Clear Masonry Sealer
Spectrum Clear Masonry Sealer can be used as a primer or bonder for cementitious surfaces.
CONCRETE & MASONRY FLOORS
RESIN TYPE: 100% Acrylic
Less than 50 g/l
FILM THICKNESS: 3-5 Mils per coat
Apply at the rate of 150-300 square feet per gallon, depending upon the condition, texture and porosity of the substrate.
Surface must be sound and free of contamination from dirt, oil, wax, releasing agents, etc. If necessary clean with appropriate cleaner, rinse, and allow to dry completely. New concrete surfaces must be allowed to cure a minimum of 30 days, be acid etched, and allowed to dry thoroughly. Previously treated, stained, or painted surfaces must be sound and clean Test for product compatibility before proceeding.
Brush, roll, or spray.
AS A SEALER: Use as a primer on concrete surfaces to prevent penetration and damage by water.
AS A BONDER: Use as a bonder on cementitious surfaces to aid in adhesion. Can also be mixed with deck aggregate to achieve decorative textures. Can also be used to secure pebbles when used as decorative roof systems.
Lace: Mix 1.25 gallons of bonder/sealer per 50 pound bag of aggregate.
Flagstone: Mix 1.50 gallons of bonder/sealer per 50 pound bag of aggregate.
Satillo Tile: Mix 2 gallons of bonder/sealer per 50 pound bag of aggregate.
THINNING: No thinning is recommended.
Touch ----------------------1 Hour
Re-coat Spray ------------ 2 Hours
Re-coat Brush/Roll -------4 Hours
Use (Traffic) ---------------24 Hours
CLEAN UP: Soap and water.
Do not apply when surface temperature, or ambient temperature is below 50 degrees F. Do not apply to exterior surfaces when rain is expected within 24 hours. Keep from freezing. Do not take internally. Keep out of the reach of children.