
Solar Shield Premium Roof Coating

Solar Shield Roof Coating is a Premium high solids 100% acrylic elastomeric coating specifically designed for the Arizona sun to provide long lasting protection from water and ultra violet ray damage to urethane foam roofs.

Available in:
RECOMMENDED USES
-
URETHANE FOAM ROOF & RE-COATS
-
RV ROOF
-
METAL ROOF
-
ASPHALT ROOF
TECHNICAL INFORMATION
RESIN TYPE: 100% Acrylic Elastomeric
VOC:
-
Less than 50 g/l
COLORS: White, tintable.
VISCOSITY: 110 - 115
FILM THICKNESS: 10 Mils per coat, 2 coat minimum for a total of 20 mil thickness.
PERCENT SOLIDS BY WEIGHT: 70 +/-2
COVERAGE
Apply at the rate of 160 square feet per gallon, depending upon the condition, texture and porosity of the substrate.
APPLICATION
SURFACE PREPARATION:
All surfaces to be coated must be sound, clean, completely cured, and chalk free. Newly applied urethane foam must be coated with the first coat within 24 daylight hours after completing the foam application.
APPLICATION:
Brush, roll, or spray. Foam Cap is to be applied at a spread rate which will yield a final film of no less than 20 Mils. This can be accomplished by applying two coats at a rate of approximately 80 square feet per gallon per coat.
AIRLESS SPRAY PUMP: Graco 433 or larger.
TIP: .031" tip size.
THINNING: No thinning is recommended.
DRYING TIME:
-
24 Hours
CLEAN UP: Soap and water.
CAUTIONS, WARNINGS:
Do not apply when surface temperature, or ambient temperature is below 50 degrees F. Do not apply to exterior surfaces when rain is expected within 24 hours. Keep from freezing. Do not take internally. Keep out of the reach of children.