Water-proofing Sealer X
Professional Waterproofing Sealer X is a clear, protective coating for use on concrete and other types of masonry materials. Treated surfaces are protected from damage caused by water penetration and are less likely to effloresce. Traffic areas become sealed from dirt and oils and can be cleaned to maintain their original appearance.
RESIN TYPE: Acrylic Solution
Less than 600 g/l
FILM THICKNESS: 3-5 Mils per coat
Apply at the rate of 150-300 square feet per gallon, depending upon the condition, texture and porosity of the substrate.
Surface must be sound and free of contamination from dirt, oil, wax, releasing agents, etc. If necessary clean with appropriate cleaner, rinse, and allow to dry completely. New concrete surfaces must be allowed to cure a minimum of 30 days, be acid etched, and allowed to dry thoroughly. Previously treated, stained, or painted surfaces must be sound and clean Test for product compatibility before proceeding.
Brush, roll, or spray. Professional Waterproofing Sealer X is a fast drying product so it is necessary to work quickly and maintain a wet edge. DO NOT apply in direct sunlight. Avoid over brushing or over rolling during application. Allow a minimum of 2 hours drying between coats.
THINNING: No thinning is recommended.
Touch ----------------------1 Hour
Recoat Spray ------------- 2 Hours
Recoat Brush/Roll --------2 Hours
Use (Light Traffic) -------- 12 Hours
Use (Heavy Traffic) ------- 72 Hours
CLEAN UP: Xylene
Do not apply when surface temperature, or ambient temperature is below 50 degrees F. Do not apply to exterior surfaces when rain is expected within 24 hours. Keep from freezing. Do not take internally. Keep out of the reach of children.
WARNING!: This product is FLAMMABLE and contains strong solvents having aromatic solvent odors. Observe all instructions and cautions of product label. Use only in well ventilated areas.